Friday, July 1, 2022

Hyper9 Motor Support and Cradle - Version 1

Purchased a Stainless Steel motor cradle from NetGain Motors (part MC-H9225 for $112.50).

The pair of galvanized steel clamping bolts are 3.5" long and 1/2"-13 coarse thread (3/4" socket head).   Stainless Steel replacement bolts for $3.13 each are available from McMaster-Carr ( https://www.mcmaster.com/93190A726/ ).

updated 7/15/2022


DSC01363 Side view of the 9" ID motor cradle. 


The engineering drawing for this cradle can be found here:

https://www.go-ev.com/PDFs/MC_H9225_Information.pdf  

updated 3/3/2023


DSC01366 Closer view of 1/2" bolt assembly of the cradle.  The bottom of the cradle uses a pair of steel narrow-base weld nuts, 1/2"-13 thread size  (McMaster 90594A033, 25 units for $22.27).  It is important to align the bolts correctly to engage the lower threads and not cross thread them..  The top fitting is just a thick washer that is crimped fit to the top of the cradle (no threads).

Updated 2/17/23


DSC01366 Top view of the cradle showing the metal band.  The steel band is 1.25" wide and when covered with the rubber bushing the total width is 1.50". 
 


DSC01366 Bottom view of  the base of the cradle.  The metal band is 3 mm thick and 37.75 mm wide (about 1.485").  The pair of mounting holes have a diameter of 0.59" (15.0 mm) and either a  9/16" or 14 mm bolt will pass freely.  The mounting holes are 215 mm (about 8 7/16") center to center.



DSC01375 Picture showing a Hyper9 body clamped within the NetGain support Cradle.



No comments:

Post a Comment